Self Cleaning rotating Grate magnet

图片3--

自动清理旋转永磁除铁器-3

图片7---

图片6---

图片5---

넳 넲

automatically clean the rotating permanent magnet iron remover, install the magnetic rod on the concentric circumference, and rotate it through the reduction motor. The main body of the equipment is connected to the pipeline of the production line with flanges, metal throat hoops, silicone hoses, etc. The material passes through the free fall from top to bottom. When the material passes through, the rotating magnetic rod can better and fully contact the material.

magnetic rod and motor are installed on the linear slide rail. When cleaning magnetic objects, the solenoid valve is energized, the cylinder pushes out the magnetic rod, and the PTFE blade on the magnetic rod scrapes the magnetic foreign matter to the non-magnetic area at the end of the magnetic rod and falls into the external magnetic material discharge pipeline. The solenoid valve is de-energized, the cylinder returns the magnetic rod to the overcurrent channel, and the magnetic material cleaning is.

characteristics

1. Compared with drawer-type permanent magnet iron remover, rotary iron remover is more suitable for materials with viscosity or poor fluidity that are easy to agglomerate, bridge and block;

2. As the magnetic rod is in a rotating state during the falling process of the material, the magnetic foreign matter can fully contact the magnetic rod and improve the demagnetization efficiency;

3. This equipment is especially suitable for high-altitude installation and manual cleaning is difficult to reach. The solenoid valve control switch can be installed on the ground and the control switch can be operated during cleaning;

4. If the PLC electric control box specially designed by our company is selected, unattended automatic demagnetization on the production line can be realized, and the demagnetization time can be set according to the process requirements;

5. The drawer door panel adopts foamed silicone rubber strip, and the cylinder is pressed and sealed. After the solenoid valve is powered off, the magnetic rod is automatically pushed back to the flow channel to ensure the sealing of the material pipeline;

6. The pipeline connection can be designed according to the customer's requirements, and the customer's on-site surveying and mapping can be carried out and the design scheme can be provided;

7. ETFE/PTFE can be sprayed on the flow channel according to customer requirements with a thickness of 0.2-0.3mm to reduce the risk of introduction of magnetic foreign matter at the back end.